AUDIO AND VISUAL SYSTEM(except Sedan Radio and Display Type) Radio Broadcast cannot be Received or Poor Reception

PROCEDURE

1. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

   1. Check the radio automatic station search function.

      1. Check the radio automatic station search function by activating it.

         Result

         Result	Proceed to
         Automatic station search function does not stop	A
         Automatic station search function stops on a station	B

   B

   REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

   Click here

   A

2. CHECK OPTIONAL COMPONENTS

   1. Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.

      Result

      Result	Proceed to
      Optional components are not installed	A
      Optional components are installed	B

      Note:

      Do not remove optional components without the permission of the customer.

   B

   REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE)

   A

3. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

   1. 

      Preparation for check

      1. Disconnect the antenna connector from the radio and display receiver assembly.

   2. Check for noise

      1. Turn the ignition swith to ACC with the radio and display receiver assembly connector connected.

      2. Turn the radio on and tune into AM mode.

      3. Place a screwdriver, thin wire or other metal object on the radio and display receiver assembly antenna jack and check that noise can be heard from the speakers.

         OK

         Noise can be heard from the speakers.

   Result

   Proceed to
   OK
   NG

   NG

   REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

   Click here

   OK

4. INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY

   1. Disconnect the RA radio and display receiver assembly connector.

   2. 

      *a	Component without harness connected (Radio and Display Receiver Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection	Condition	Specified Condition
      RA-5 (ANT+) - Body ground	Ignition switch ACC Radio switch on and FM or AM selected	11 to 14 V

   Result

   Proceed to
   OK
   NG

   NG

   REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

   Click here

   OK

5. REPLACE ANTENNA CORD SUB-ASSEMBLY

   1. Replace the antenna cord sub-assembly with a new or known good one and check if radio broadcasts can be received normally.

      for Wagon:Click here

      for Hatchback:Click here

      OK

      Radio broadcasts can be received normally.

   Result

   Proceed to
   OK
   NG

   OK

   NORMAL OPERATION

   NG

6. REPLACE NO. 3 ANTENNA CORD SUB-ASSEMBLY

   1. Replace the No. 3 antenna cord sub-assembly with a new or known good one and check if radio broadcasts can be received normally.

      for Wagon:Click here

      for Hatchback:Click here

      OK

      Radio broadcasts can be received normally.

   Result

   Proceed to
   OK
   NG

   OK

   NORMAL OPERATION

   NG

7. REPLACE NO. 1 AMPLIFIER ANTENNA ASSEMBLY

   1. Replace the No. 1 amplifier antenna assembly with a new or known good one and check if radio broadcasts can be received normally.

      for Wagon:Click here

      for Hatchback:Click here

      OK

      Radio broadcasts can be received normally.

      Result

      Proceed to
      OK
      NG

   OK

   NORMAL OPERATION

   NG

   REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

   Click here