STOP AND START


  1. OPERATION


    1. The combination meter assembly receives the idling on/off signals from the engine stop and start ECU.

    2. By changing the display mode of the multi-information display by operating the multi-information switch on the steering pad switch assembly, the amount of time idling stop was performed since the engine switch was turned on (IG) to when the engine switch was turned off or the amount of time idling stop was performed since the reset switch was last pressed can be displayed.

    3. The system operation status or warning information is indicated to the driver through the following means:


      • Illuminating or flashing the stop and start indicator light and stop and start cancel indicator light on the multi-information display in the combination meter assembly.

      • Sounding a buzzer.

      • Displaying other information on the multi-information display.

      B002FJMC01
      *1 Stop and Start Indicator Light *2 Stop and Start Cancel Indicator Light
      *3 Multi-information Display - -
      Stop and Start Indicator Light Operation
      Item Condition Stop and Start Indicator Light Buzzer
      System Operating (Engine is stopped) The vehicle is operating normally. Illuminates Does not sound
      Stop and Start Cancel Indicator Light Operation
      Condition Stop and Start Cancel Indicator Light
      The vehicle is stopped and system operation conditions are met. OFF
      When the stop and start system cancel switch assembly is ON. Illuminates
      When any Diagnostic Trouble Code (DTCs) are detected. Blinks*
      When the number of times the starter assembly has been operated exceeds the threshold.

      Tech Tips

      *: The blinking interval is 0.5 seconds.

      Multi-information Display Operation
      Display Operation Condition Multi-information Display
      System Malfunction Display A system malfunction is detected.

      Stop & Start System Malfunction

      Visit Your Dealer

      Display of Temporary Cancellation of Idling Stop Operation The driver's seatbelt is unfastened during idling stop. Driver seat belt unbuckled
      The driver operates the steering wheel more than a specified angle during idling stop. Steering wheel turned
      Hydraulic pressure of brakes becomes insufficient during idling stop. For brake system
      Cooling performance of the air conditioning system deteriorates during idling stop. For climate control
      Battery charge amount decreases during idling stop. Battery charging
      Other control can cellation conditions. Stop & start unavaiable
      Display of Prohibition Status of Stop and Start Control Battery charge amount decreases and becomes insufficient for the engine stop requirements. Battery charging
      Hydraulic pressure of brakes is insufficient. For brake system
      Depress brake firmly to activate. Driver seat belt unbuckled
      When a battery that is not specified is used and the battery voltage is below the lowest engine starting voltage. Non-Dedicated Battery
      Display of Standby State of Stop and Start Control Brake pedal depression is insufficient for the engine stop requirement. Depress brake firmly to activate.
      Other control can cellation conditions. Stop & start unavaiable