EXHAUST PIPE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during front exhaust pipe assembly, center exhaust pipe assembly (TWC: Rear Catalyst), tail exhaust pipe assembly and No. 2 tail exhaust pipe assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

B007ZGP

PROCEDURE


  1. REMOVE HEATED OXYGEN SENSOR

    Click here

  2. REMOVE EXHAUST PIPE DAMPER

    CAUTION:

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


    1. A01RBB8

      Remove the 2 bolts and exhaust pipe damper from the tail exhaust pipe assembly.

  3. REMOVE NO. 2 TAIL EXHAUST PIPE ASSEMBLY

    CAUTION:

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


    1. A01RBBP

      Remove the 2 bolts and disconnect the No. 2 tail exhaust pipe assembly from tail exhaust pipe assembly.

    2. Remove the No. 2 tail exhaust pipe assembly from the 2 exhaust pipe supports.

    3. Remove the exhaust pipe gasket from the tail exhaust pipe assembly.

  4. REMOVE TAIL EXHAUST PIPE ASSEMBLY

    CAUTION:

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


    1. A01R926

      Remove the 2 bolts and 2 compression springs and disconnect the tail exhaust pipe assembly from the center exhaust pipe assembly (TWC: Rear Catalyst).

    2. Remove the tail exhaust pipe assembly from the 2 exhaust pipe supports.

    3. Remove the exhaust pipe gasket from the center exhaust pipe assembly (TWC: Rear Catalyst).

  5. REMOVE CENTER EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

    CAUTION:

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


    1. A01RCLD

      Remove the 2 nuts and disconnect the center exhaust pipe assembly (TWC: Rear Catalyst) from the front exhaust pipe assembly.

    2. Remove the center exhaust pipe assembly (TWC: Rear Catalyst) from the 2 exhaust pipe supports.

    3. Remove the exhaust pipe gasket from the front exhaust pipe sub-assembly.

  6. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    CAUTION:

    To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


    1. A01RDGM

      Remove the 2 bolts, 2 compression springs and front exhaust pipe sub-assembly from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).

    2. Remove the exhaust pipe gasket from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).