AUDIO AND VISUAL SYSTEM Sound Quality is Bad Only when Disc is Played (Volume is Too Low)

CAUTION / NOTICE / HINT

Note

When replacing the radio receiver assembly, always replace it with a new one.

If a radio receiver assembly which was installed to another vehicle is used, the following may occur:


  • A communication malfunction DTC may be stored.

  • The radio receiver assembly may not operate normally.

Tech Tips

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click here

PROCEDURE


  1. REPLACE DISC AND RECHECK


    1. Replace the disc with a known good one and check that the malfunction disappears.

      OK
      Malfunction disappears.
      Result
      Proceed to
      OK
      NG

    OK

    END (DISC IS DEFECTIVE)

    NG

    REPLACE RADIO RECEIVER ASSEMBLY Click here