BRAKE BOOSTER(for RHD) COMPONENTS
ILLUSTRATION
| *1 | NO. 1 AIR DUCT SUB-ASSEMBLY | *2 | NO. 1 HEATER TO REGISTER DUCT |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | BRAKE BOOSTER ASSEMBLY | *2 | BRAKE BOOSTER BRACKET |
| *3 | BRAKE MASTER CYLINDER PUSH ROD CLEVIS | *4 | BRAKE PEDAL RETURN SPRING |
| *5 | PUSH ROD PIN | *6 | BOOSTER BRACKET STOPPER RING (The booster bracket stopper ring is used as a jig during assembly at the factory.When installing the brake booster assembly, it is not necessary to install a booster bracket stopper ring.) |
| *7 | BRAKE BOOSTER GASKET | *8 | CLEVIS LOCK NUT |
| *9 | BRAKE LINE | *10 | CLAMP |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | * | For use with a union nut wrench |
| ● | Non-reusable part |  |
Lithium soap base glycol grease |
ILLUSTRATION
| *1 | VACUUM SENSOR ASSEMBLY | *2 | VACUUM SENSOR GROMMET |
| *3 | VACUUM WARNING SWITCH ASSEMBLY | *4 | VACUUM WARNING SWITCH GROMMET |
| *5 | BRAKE VACUUM CHECK VALVE ASSEMBLY | *6 | CHECK VALVE GROMMET |
| ● | Non-reusable part | - | - |