STEERING ANGLE SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note:

A lock pin is installed to a new steering sensor. Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.

PROCEDURE

  1. INSPECT SPIRAL CABLE SUB-ASSEMBLY

    Click hereClick here

  2. INSTALL STEERING SENSOR

    1. C142627C02

      *a

      Guide

      *b

      Pin

      *c

      Lock Pin

      Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.

      Note:

      • Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.

      • Do not damage the pins of the spiral cable sub-assembly and guides of the steering sensor.

      • The spiral cable sub-assembly can be rotated up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable sub-assembly.

    2. C142628

      Remove the lock pin from the steering sensor.

  3. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click hereClick here