STARTER REASSEMBLY

CAUTION / NOTICE / HINT

PROCEDURE

  1. INSTALL PLANETARY GEAR

    1. Apply high-temperature grease to the planetary gears of the planetary shaft.

    2. A294293C01
      V100135

      High-temperature Grease

      Install the 3 planetary gears.

  2. INSTALL STARTER ARMATURE PLATE

    1. A086452C01

      *a

      Protrusion

      *b

      Cutout

      Install the starter armature plate to the starter center bearing clutch sub-assembly.

      Note:

      Check that the cutout of the starter center bearing clutch sub-assembly fits over the protrusion of the starter armature plate.

  3. INSTALL STARTER ARMATURE ASSEMBLY

    1. Install the starter armature assembly to the starter center bearing clutch sub-assembly.

  4. INSTALL STARTER YOKE ASSEMBLY

    1. A165179C01

      *a

      Cutout

      *b

      Protrusion

      Align the protrusion of the starter center bearing clutch sub-assembly with the cutout of the starter yoke assembly, and install the starter yoke assembly.

  5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY

    1. Install the starter brush holder assembly.

    2. A030137

      Using a screwdriver, hold the brush spring back and connect the brush into the starter brush holder assembly.

    3. Connect the 4 brushes.

    4. A206778

      Align the starter commutator end frame assembly rubber with the groove of the starter yoke assembly.

    5. A165167

      Install the starter commutator end frame assembly with the 2 screws.

      3.8 N*m

      39 kgf*cm

      34 in.*lbf

  6. INSTALL STARTER DRIVE HOUSING ASSEMBLY

    1. A294294C01
      V100135

      High-temperature Grease

      Apply high-temperature grease to the starter pinion drive lever.

    2. A202456

      Install the starter pinion drive lever to the starter center bearing clutch sub-assembly.

    3. A202464

      Align the claw of the starter center bearing clutch sub-assembly with the groove inside the starter drive housing assembly, and install the starter center bearing clutch sub-assembly to the starter drive housing assembly.

    4. A165166

      Using a T30 "TORX" driver, install the starter drive housing assembly with the 2 through bolts.

      6.0 N*m

      61 kgf*cm

      53 in.*lbf

  7. INSTALL STARTER MAGNETIC SWITCH ASSEMBLY

    1. A165165

      Install the starter magnetic switch assembly with the 2 nuts.

      7.5 N*m

      76 kgf*cm

      66 in.*lbf

    2. A165164

      Connect the lead wire to the starter magnetic switch assembly with the nut.

      6.5 N*m

      66 kgf*cm

      58 in.*lbf