CAMSHAFT POSITION SENSOR INSTALLATION


  1. INSTALL CAMSHAFT POSITION SENSOR


    1. for Intake Side:


      1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

      2. Install the camshaft position sensor with the bolt.

        Torque:
        9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

        Note


        • When reusing the camshaft position sensor, inspect the O-ring.

        • Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.

      3. Connect the camshaft position sensor connector.

    2. for Exhaust Side:


      1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

      2. Install the camshaft position sensor with the bolt.

        Torque:
        9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

        Note


        • When reusing the camshaft position sensor, inspect the O-ring.

        • Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.

      3. Connect the camshaft position sensor connector.

  2. INSTALL INTAKE AIR CONNECTOR


    1. Temporarily install the intake air connector to the throttle body assembly.

    2. Connect the vacuum hose to the intake air connector.

    3. Connect the No. 2 PCV hose to the cylinder head cover sub-assembly, and slide the clamp to secure the hose.

    4. Install the intake air connector with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }
    5. B007QBBE01

      Tighten the 2 hose clamps.

      Torque:
      for clamp A
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  3. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY


    1. Install the engine service hole cover sub-assembly with the 5 bolts.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  4. INSTALL FRONT DOOR SCUFF PLATE RH

  5. INSTALL FRONT SEAT ASSEMBLY RH

    Click here