ULTRASONIC SENSOR INSTALLATION

PROCEDURE


  1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER


    1. A005A1CE02
      Text in Illustration
      *a Snap
      *b Keyhole

      Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the front bumper assembly.

      Note


      • Do not damage the front bumper with the protrusion when installing the retainer.

      • Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the front bumper.

      Tech Tips


      • When installing the retainer, align the keyhole and snap as shown in the illustration.

      • The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.

  2. INSTALL NO. 1 ULTRASONIC SENSOR


    1. Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.

      Note

      Push the No. 1 ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.

      Tech Tips

      Use the same procedure for the RH side and LH side.

  3. INSTALL ULTRASONIC SENSOR CLIP


    1. Engage the 4 claws to install the ultrasonic sensor clip.

    2. Engage the clamp.

    3. Connect the connector.

      Tech Tips

      Use the same procedure for the RH side and LH side.

  4. INSTALL FRONT BUMPER ASSEMBLY

    Click here