REAR VIEW MONITOR SYSTEM (for Radio and Display Type) HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips

Use these procedures to troubleshoot the rear view monitor system.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. CUSTOMER PROBLEM ANALYSIS


    NEXT

  3. CHECK DTC OF AUDIO AND VISUAL SYSTEM (for Radio and Display Type)


    1. Refer to DTC Check/Clear procedures of the audio and visual system (for Radio and Display Type) Click here.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

      B

      GO TO AUDIO AND VISUAL SYSTEM (for Radio and Display Type) Click here

      A

  4. PROBLEM SYMPTOM CONFIRMATION

    Result
    Result Proceed to
    Symptom does not occur A
    Symptom occurs B

    B

    Go to step 6
    A

  5. SYMPTOM SIMULATION


    NEXT

  6. CHECK IF SAME SYMPTOM APPEARS IN AUDIO AND VISUAL SYSTEM (for Radio and Display Type)


    1. Refer to the audio and visual system (for Radio and Display Type) Click here.

      Result
      Result Proceed to
      Symptom does not appear A
      Symptom appears B

      B

      FOLLOW THE AUDIO AND VISUAL SYSTEM SYMPTOM CHART TO PERFORM TROUBLESHOOTING
      A

  7. PROBLEM SYMPTOMS TABLE


    1. Refer to the problem symptoms table Click here.

      Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

      B

      Go to step 9
      A

  8. BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW


    1. Terminals of ECU Click here.


      NEXT

  9. ADJUST, REPAIR OR REPLACE


    NEXT

  10. CONFIRMATION TEST


    NEXT
    END