REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE HYBRID VEHICLE TRANSMISSION ASSEMBLY

    Click here

  2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY


    1. A01OAZSN02

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015

      Tech Tips

      Part number of the installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. A01OCR4

      Remove the 6 bolts and transmission input damper assembly from the flywheel sub-assembly.

  3. REMOVE FLYWHEEL SUB-ASSEMBLY


    1. A01OAZSN03

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015

      Tech Tips

      Part number of the installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. A01OBB6

      Remove the 8 bolts and flywheel sub-assembly from the crankshaft.

  4. REMOVE REAR ENGINE OIL SEAL


    1. A01OBR0C05
      *a Cut Position
      *b Protective Tape

      Using a knife, cut off the lip of the rear engine oil seal.

    2. Using a screwdriver, pry out the rear engine oil seal.

      Note

      Do not damage the surface of the press fit hole or the crankshaft.

      Tech Tips

      Tape the screwdriver tip before use.