FORWARD RECOGNITION CAMERA SYSTEM, Diagnostic DTC:U023A

DTC Code DTC Name
U023A Lost Communication with Front Camera Module

DESCRIPTION

When a communication error between the forward recognition camera and the power steering ECU assembly is detected, the forward recognition camera notifies other ECUs and DTC U023A is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
U023A Lost Communication with Front Camera Module 3 seconds after the ignition switch is turned to ON, a communication malfunction between the forward recognition camera and the power steering ECU assembly is detected for 5 seconds or more.

  • CAN communication system

  • Forward recognition camera

  • Power steering ECU assembly

CAUTION / NOTICE / HINT

Note


  • When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

  • If the forward recognition camera has been replaced with a new one, be sure to perform Forward Recognition Camera Learning.

    Click here

  • The forward recognition camera system uses the CAN communication system. First, confirm that there are no malfunction in the CAN communication system. Refer to How to Proceed with Troubleshooting.

    Click here

PROCEDURE


  1. CHECK FOR DTCs (POWER STEERING SYSTEM)

    Tech Tips

    When the forward recognition camera system outputs DTC U023A, the power steering system may also output DTC U023A. If DTC U023A is output, perform diagnosis for the power steering system first.


    1. Check for DTCs.

      Click here


      Chassis > EMPS > Trouble Codes
      Result
      Result Proceed to
      DTC U023A is not output A
      DTC U023A is output B

    B

    GO TO POWER STEERING SYSTEM Click here

    A

  2. CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM)


    1. Clear the DTCs.

      Click here


      Chassis > Front Recognition Camera > Clear DTCs

    2. Perform the following procedure.

      Tech Tips

      If the following procedure is not performed, the previously output DTC cannot be detected.


      1. Turn the ignition switch to ON and wait 8 seconds or more.

    3. Check for DTCs.

      Click here


      Chassis > Front Recognition Camera > Trouble Codes
      Result
      Result Proceed to
      DTC U023A is not output A
      DTC U023A is output B

    A

    USE SIMULATION METHOD TO CHECK Click here

    B

  3. REPLACE FORWARD RECOGNITION CAMERA


    1. Replace the forward recognition camera.

      Click here

    2. Perform Forward Recognition Camera Learning.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM)


    1. Clear the DTCs.

      Click here


      Chassis > Front Recognition Camera > Clear DTCs

    2. Perform the following procedure.

      Tech Tips

      If the following procedure is not performed, the previously output DTC cannot be detected.


      1. Turn the ignition switch to ON and wait 8 seconds or more.

    3. Check for DTCs.

      Click here


      Chassis > Front Recognition Camera > Trouble Codes
      Result
      Result Proceed to
      DTC U023A is not output A
      DTC U023A is output (for LHD) B
      DTC U023A is output (for RHD) C

    A

    END (FORWARD RECOGNITION CAMERA WAS DEFECTIVE)

    B

    REPLACE POWER STEERING ECU ASSEMBLY Click here

    C

    REPLACE POWER STEERING ECU ASSEMBLY Click here