CHARGING SYSTEM PRECAUTION

  1. INITIALIZATION

    Note:

    • Perform Registration (Switch Battery Type) when replacing the ECM (w/ Stop and Start System).

      Click here

    • When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

    System Name

    See Procedure

    Stop and Start System

    Click hereClick hereClick hereClick here

    Simple Intelligent Parking Assist System

    Power door lock control system (for Hatchback, Wagon)

  2. IGNITION SWITCH EXPRESSIONS

    Tip:

    The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression

    Ignition Switch (Position)

    Engine Switch (Condition)

    Ignition Switch off

    LOCK

    Off (Lock)

    Ignition Switch ACC

    ACC

    On (ACC)

    Ignition Switch ON

    ON

    On (IG)

    Engine Start

    START

    On (Start)

  3. CHARGING SYSTEM PRECAUTION

Note:

  • Check that the battery cables are connected to the correct terminals.

  • Disconnect the battery cables when the battery is given a quick charge.

  • Do not perform tests with a high voltage insulation resistance tester.

  • Never disconnect the battery cables while the engine is running.

  • Check that the charging cable nuts are tightened on terminal B of the generator assembly and on the engine room relay block and junction block assembly.