BRAKE MASTER CYLINDER(for LHD) DISASSEMBLY

PROCEDURE

  1. REMOVE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY

    1. Mount the brake master cylinder sub-assembly in a vise.

      Note:

      Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.

    2. for Type A Brake Master Cylinder Sub-assembly:

      1. C273649

        Using an E7 "TORX" socket wrench, remove the "TORX" screw and brake master cylinder reservoir assembly from the brake master cylinder body.

        Note:

        Do not drop the brake master cylinder reservoir assembly.

      2. C273650

        Disengage the claw to remove the wire harness clamp bracket.

    3. for Type B Brake Master Cylinder Sub-assembly:

      1. C156017

        Using a 5 mm pin punch and a hammer, tap out the brake master cylinder ring pin from the brake master cylinder sub-assembly.

        Note:

        Do not drop the brake master cylinder reservoir assembly.

      2. Remove the brake master cylinder reservoir assembly from the brake master cylinder body.

    4. Remove the brake master cylinder body from the vise.

  2. REMOVE MASTER CYLINDER RESERVOIR GROMMET

    1. Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir assembly.

  3. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

  4. REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER