REAR AXLE HUB BOLT(for Torsion Beam Type Suspension) REPLACEMENT

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. REMOVE REAR WHEEL

  2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    for Hatchback, Wagon:Click hereClick here

    for Sedan:Click hereClick here

  3. LOOSEN NO. 2 WIRE ADJUSTING NUT

    Click here

  4. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click hereClick here

  5. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    1. Remove the 2 bolts and separate the rear disc brake caliper assembly.

      Note:

      Use wire or an equivalent tool to keep the rear disc brake caliper assembly from hanging by the rear flexible hose.

  6. REMOVE REAR DISC

    Click hereClick here

  7. REMOVE REAR AXLE HUB BOLT

    1. C272867C01

      *a

      Service Nut

      Temporarily install 2 service nuts to the rear axle hub bolts as shown in the illustration.

      Recommended Service Nut

      Thread diameter: 12.0 mm (0.472 in.)

      Thread pitch: 1.5 mm (0.0591 in.)

      Note:

      Install the service nuts to prevent damage to the rear axle hub bolts.

    2. Using SST and a screwdriver or an equivalent tool to hold the rear axle hub and bearing assembly, remove the rear axle hub bolt.

      09611-12010

      Note:

      Do not damage the threads of the rear axle hub bolts.

  8. INSTALL REAR AXLE HUB BOLT

    1. C272868C01

      *a

      Service Nut

      *b

      Washer

      Temporarily install a new rear axle hub bolt to the rear axle hub and bearing assembly.

    2. Install a washer and service nut to the rear axle hub bolt as shown in the illustration.

      Recommended Service Nut

      Thread diameter: 12.0 mm (0.472 in.)

      Thread pitch: 1.5 mm (0.0591 in.)

      Tip:

      Recommended washer thickness is 5 mm (0.197 in.) or more.

    3. Using a screwdriver or an equivalent tool to hold the rear axle hub and bearing assembly, install the rear axle hub bolt by tightening the service nut.

      Note:

      • Install the service nuts to prevent damage to the rear axle hub bolts.

      • Do not damage the threads of the rear axle hub bolts.

    4. Remove the 3 service nuts and washer from the 3 rear axle hub bolts.

  9. INSTALL REAR DISC

    Click hereClick here

  10. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    1. Install the rear disc brake caliper assembly with the 2 bolts.

      72 N*m

      734 kgf*cm

      53 ft.*lbf

  11. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click hereClick here

  12. ADJUST PARKING BRAKE

    Click hereClick here

  13. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

    for Hatchback, Wagon:Click hereClick here

    for Sedan:Click hereClick here

  14. INSTALL REAR WHEEL

    103 N*m

    1050 kgf*cm

    76 ft.*lbf