OUTER REAR VIEW MIRROR GLASS REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE OUTER MIRROR


    1. A01OBFLC01
      B008GB8 Protective Tape

      Apply protective tape to the area shown in the illustration.

    2. Push the upper part of the mirror surface to tilt the outer mirror.

    3. Using a moulding remover, disengage the 2 claws on the lower part of the outer mirror as shown in the illustration.

    4. A01OA7XC01
      B008GB8 Protective Tape

      Apply protective tape to the area shown in the illustration.

    5. Push the lower part of the mirror surface to tilt the outer mirror.

    6. Using a moulding remover, disengage the 2 claws on the upper part of the outer mirror as shown in the illustration.

    7. A01OCVG

      Disengage the clamp.

    8. Disconnect the 2 mirror heater connectors.

    9. w/ EC Mirror:


      1. A01OBKC

        Disengage the 3 clamps.

      2. Release the tabs of the EC mirror connector and disconnect the EC mirror connector.

        Note


        • Do not bend the tabs excessively to prevent them from being damaged.

        • If the tabs are damaged, replace the outer mirror with a new one.

    10. w/ Blind Spot Monitor System:


      1. A01OC8S

        Disengage the 3 clamps.

      2. Release the tabs of the blind spot monitor indicator connector and disconnect the blind spot monitor indicator connector.

        Note


        • Do not bend the tabs excessively to prevent them from being damaged.

        • If the tabs are damaged, replace the outer mirror actuator assembly with a new one.

    11. Remove the outer mirror.