РАДИАТОР СНЯТИЕ


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. REMOVE RADIATOR GRILLE


    1. A01DYIBE01
      Обозначения на рисунке
      *1 Защитная клейкая лента

      Наклейте защитную клейкую ленту вокруг решетки радиатора.

    2. Выверните 2 винта и освободите 2 фиксатора.

    3. A01DY0N

      Расцепите 6 захватов и снимите решетку радиатора.

  3. REMOVE RADIATOR SIDE DEFLECTOR LH


    1. A01E1U8

      Using a clip remover, remove the 2 clips.

    2. Detach the claw and remove the deflector.

  4. REMOVE RADIATOR SIDE DEFLECTOR RH


    1. Using a clip remover, remove the 2 clips.

    2. Detach the claw and remove the deflector.

  5. DRAIN ENGINE COOLANT


    1. Remove the radiator cap.

    2. Loosen the cylinder block drain cock plug and radiator drain cock plug, and then drain the coolant.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

      A01DZG1E01
  6. REMOVE RADIATOR HOSE INLET

  7. REMOVE RADIATOR HOSE OUTLET

  8. REMOVE FAN SHROUD

    A01E1G2E02

    1. Disconnect the reservoir hose from the radiator tank upper.

    2. Loosen the 4 nuts holding the fluid coupling fan.

    3. Remove the drive belt Click here.

    4. Remove the 2 bolts holding the fan shroud.

    5. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

      Note

      Be careful not to damage the radiator core.

    6. Remove the fan pulley from the water pump.

  9. REMOVE RADIATOR ASSEMBLY


    1. A01E2KT

      Disconnect the 2 airbag sensor front connectors.

    2. Using a clip remover, detach the 4 clamps from the radiator side as shown in the illustration.

      Tech Tips

      Tape the clip remover tip before use.

    3. A01DZ1ZE01

      Remove the 4 bolts and radiator.