FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE V-RIBBED BELT

    Click here

  2. REMOVE CRANKSHAFT PULLEY ASSEMBLY


    1. A01RAI1C01
      *1 Washers
      *a Hold
      *b Turn

      Using SST, hold the crankshaft pulley assembly, and loosen the crankshaft pulley set bolt. Further loosen the crankshaft pulley set bolt until 2 or 3 threads remain screwed into the crankshaft.

      SST
      09213-70011
      09213-54015   ( 09214-00030 )
      09330-00021

      Tech Tips

      Insert a few washers (total thickness: approximately 5.0 mm (0.197 in.)) between SST (09213-70011) and SST (09214-00030).

    2. A01RFCBC01
      *1 Crankshaft Pulley Set Bolt
      *a Hold
      *b Turn

      Using SST, remove the crankshaft pulley assembly and crankshaft pulley set bolt.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05011 )

      Tech Tips

      Apply lubricant to the threads and end of SST.

  3. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    1. A01RCSVC01
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, pry out the timing gear case or timing chain case oil seal.

      Note


      • Do not damage the surface of the press fit hole or crankshaft.

      • After removing the timing gear case or timing chain case oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.