NETWORK GATEWAY ECU REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE FRONT STEERING CONTROL ECU (w/ VGRS)

   Click here

2. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/o VGRS)

   Click here

3. REMOVE INSTRUMENT SIDE PANEL LH (w/o VGRS)

   Click here

4. REMOVE LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY (w/o VGRS)

   Click here

5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/o VGRS)

   Click here

6. REMOVE GLOVE COMPARTMENT DOOR PAD PLATE (w/o VGRS)

   Click here

7. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (w/o VGRS)

   Click here

8. REMOVE PASSENGER SIDE JUNCTION BLOCK ASSEMBLY WITH NETWORK GATEWAY ECU

   
   

   1. 

      Disconnect the clamp.

   2. Disconnect the 3 connectors.

   3. Disconnect the 2 connectors.

      

      *a	Lever Connector
      	Rotate in this Direction		Protective Tape

   4. Using a thin-bladed screwdriver with its tip wrapped with protective tape, detach the claw and disconnect the 2 lever connectors.

   5. 

      *a	Nut (A)
      *b	Nut (B)

      w/ VGRS:

      
      

      1. Remove the nut (A).

         Note

         If the removed nut is the same shape as that shown in the illustration, replace it the supplied replacement part.

         

   6. w/o VGRS:

      
      

      1. Remove the nut (A) and nut (B).

         Note

         If the removed nut is the same shape as that shown in the illustration, replace it the supplied replacement part.

         

   7. Detach the claw and remove the passenger side junction block with network gateway ECU assembly.

      

      *a	Lever Connector	-	-
      	Rotate in this Direction		Protective Tape

   8. Disconnect the connector.

   9. Using a thin-bladed screwdriver with its tip wrapped with protective tape, detach the claw and disconnect the 2 lever connectors.

9. REMOVE NETWORK GATEWAY ECU

   
   

   1. 

      Remove in this Direction

      Detach the claw and guide and remove the network gateway ECU.