REAR AXLE HUB REMOVAL

CAUTION / NOTICE / HINT

Note

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Click here.

  2. DISABLE BRAKE CONTROL

    Click here

  3. REMOVE REAR WHEEL

  4. DISCONNECT SKID CONTROL SENSOR WIRE

    Click here

  5. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  6. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

  7. REMOVE REAR DISC

    Click here

  8. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    1. B005ZPJ

      Remove the 4 bolts, rear axle hub and bearing assembly from the rear axle beam assembly.