RADIATOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intercooler cooling radiator removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Front television camera assembly

  • Front bumper assembly

  • Radiator grille

 Front television camera view adjustment Panoramic view monitor system

Click here for Initialization

Click here for Calibration
Front bumper assembly (w/ Intelligent clearance sonar system)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

 Intelligent clearance sonar system

Click here

PROCEDURE


  1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

    for HFC-134a (R134a):

    Click here

    for HFO-1234yf (R1234yf):

    Click here

  2. DRAIN COOLANT (for Intercooler)

    Click here

  3. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  4. REMOVE HOOD LOCK CONTROL CABLE COVER (for LHD)

    Click here

  5. REMOVE HOOD LOCK CONTROL CABLE COVER (for RHD)

    Click here

  6. REMOVE HOOD LOCK RELEASE LEVER PROTECTOR

    Click here

  7. REMOVE HOOD LOCK ASSEMBLY

    Click here

  8. REMOVE INLET AIR CLEANER ASSEMBLY

    Click here

  9. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY

    Click here

  10. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

    Click here

  11. DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY

    Click here

  12. DISCONNECT NO. 3 INTERCOOLER COOLING WATER HOSE


    1. B007YIK

      Using pliers, grip the claws of the clip and slide the clip to disconnect the No. 3 intercooler cooling water hose.

      Note


      • Do not apply excessive force to the No. 3 intercooler cooling water hose.

      • Prepare a drain pan or cloth in case the coolant leaks.

  13. DISCONNECT NO. 2 INTERCOOLER COOLING WATER HOSE


    1. B007Z48

      Using pliers, grip the claws of the clip and slide the clip to disconnect the No. 2 intercooler cooling water hose.

      Note


      • Do not apply excessive force to the No. 2 intercooler cooling water hose.

      • Prepare a drain pan or cloth in case the coolant leaks.

  14. REMOVE WATER BY-PASS HOSE


    1. B007Y08

      Disengage the clamp.

    2. Slide the clip to disconnect the water by-pass hose from the intercooler cooling radiator assembly.

  15. REMOVE COOLER CONDENSER ASSEMBLY WITH INTERCOOLER COOLING RADIATOR ASSEMBLY

    Click here

  16. REMOVE COOLER CONDENSER ASSEMBLY

    Click here

  17. REMOVE INTERCOOLER COOLING RADIATOR ASSEMBLY