GLOW PLUG INSTALLATION

PROCEDURE

1. INSTALL GLOW PLUG ASSEMBLY

   1. Clean the glow plug assembly installation holes in the cylinder head sub-assembly.

   2. Using a 10 mm deep socket wrench, install the 4 glow plug assemblies.

      12 N*m

      122 kgf*cm

      9 ft.*lbf

2. INSTALL NO. 1 GLOW PLUG CONNECTOR

   1. Install the No. 1 glow plug connector with the 4 nuts.

      2.2 N*m

      22 kgf*cm

      19 in.*lbf

   2. Connect the clamp to the bracket.

   3. Install the 4 grommets.

   4. Connect the engine wire with the bolt.

      13 N*m

      133 kgf*cm

      10 ft.*lbf

   5. Connect the glow connector.

3. INSTALL ENGINE COVER BRACKET

   1. 

      *a	Nut
      *b	Bolt

      Install the engine cover bracket with the bolt and nut.

      Bolt

      20 N*m

      204 kgf*cm

      15 ft.*lbf

      Nut

      8.4 N*m

      86 kgf*cm

      74 in.*lbf

4. INSTALL NO. 2 EGR PIPE SUB-ASSEMBLY

   Click here

5. INSTALL NO. 1 ENGINE COVER

   Click here

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click hereClick here