BRAKE MASTER CYLINDER(for LHD) REASSEMBLY

PROCEDURE

  1. INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER

  2. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

  3. INSTALL MASTER CYLINDER RESERVOIR GROMMET

    1. Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new master cylinder reservoir grommets.

    2. Install the 2 master cylinder reservoir grommets to the brake master cylinder reservoir assembly.

  4. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY

    1. C273650

      Engage the claw to install the wire harness clamp.

    2. Mount the brake master cylinder body in a vise.

      Note:

      Place aluminum plates on the vise to prevent damage to the brake master cylinder body.

    3. Install the brake master cylinder reservoir assembly to the brake master cylinder body.

      Note:

      Do not drop the brake master cylinder reservoir assembly.

    4. C273649

      Using an E7 "TORX" socket wrench, install the brake master cylinder reservoir assembly to the brake master cylinder body with the "TORX" screw.

      4.0 N*m

      41 kgf*cm

      35 in.*lbf

    5. Remove the brake master cylinder sub-assembly from the vise.