REAR DOOR SPEAKER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR NO. 2 SPEAKER ASSEMBLY (for 10 Speakers)


    1. A004U2FE02

      Align the speaker with the door position pins labeled A.

    2. Install the speaker with the 2 screws.

      Note

      Do not touch the cone part of the speaker.

    3. Attach the clamp.

  2. INSTALL REAR NO. 1 SPEAKER ASSEMBLY


    1. Temporarily install the speaker by attaching the claw of the speaker to the door panel.

      Note

      Do not touch the cone part of the speaker.

    2. A004T9BE01

      Using an air riveter or hand riveter, install the speaker with 3 new rivets in the order shown in the illustration.

      Note


      • A004RW4E66

        Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

        Text in Illustration
        *1 INCORRECT
        *2 CORRECT
        *3 Mandrel
        *4 Riveter
      • A004RNQE44

        Confirm that the rivets are seated properly against the speaker.

        Text in Illustration
        *1 INCORRECT
        *2 CORRECT
        *3 Riveter

      • Do not tilt the riveter when installing the rivet to the speaker.

      • Do not leave any space between the rivet head and speaker.

      • A004PZTE11

        Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.

        Text in Illustration
        *1 INCORRECT
        *2 CORRECT
        *3 Riveter

    3. Connect the connector.

  3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  4. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  5. INSTALL DOOR ASSIST GRIP COVER LH

    Click here

  6. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  7. INSTALL REAR DOOR REGULATOR INSIDE HANDLE PLATE (w/o Power Window)

    Click here

  8. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.