MANUAL TRANSAXLE SYSTEM DATA LIST / ACTIVE TEST

  1. DATA LIST

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the GTS to the DLC3.

    4. Turn the ignition switch to ON.

    5. Turn the GTS on.

    6. Enter the following menus: Powertrain / Transmission / Data List.

    7. According to the display on the GTS, read the Data List.

      Powertrain > Transmission > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      Total Distance Traveled

      Total distance traveled

      Min.: 0

      Max.: 16777215

      -

      -

      Total Distance Traveled - Unit

      Unit for total distance traveled

      km or mile

      -

      -

      BATT Voltage

      Battery voltage

      Min.: 0.000 V

      Max.: 79.998 V

      11 to 14 V: Engine idling

      -

      Starter SW

      Starter signal

      ON or OFF

      • ON: Starter operating

      • OFF: Starter not operating

      -

      Neutral Position SW

      Clutch switch status

      ON or OFF

      • ON: Clutch pedal depressed

      • OFF: Clutch pedal not depressed

      -

      Stop Light SW

      Stop light switch status

      ON or OFF

      • ON: Brake pedal depressed

      • OFF: Brake pedal released

      -

      Cruise Main SW

      Cruise control switch status

      ON or OFF

      -

      -

      NIM Sensor Test Results

      Check mode result for NIM sensor

      Compl or Incmpl

      -

      -

      Accel Position from EFI

      Accelerator pedal position

      Min.: 0%

      Max.: 127.5%

      Actual accelerator pedal position

      -

      Shift SW Status (R Range)

      Back-up light switch status

      ON or OFF

      • ON: Shift lever in R

      • OFF: Shift lever not in R

      -