CRUISE CONTROL SYSTEM(except 1ND-TV, 8NR-FTS)

CAUTION / NOTICE / HINT

PROCEDURE

1. VEHICLE BROUGHT TO WORKSHOP

   Result

   Proceed to
   NEXT

   NEXT

2. INSPECT BATTERY VOLTAGE

   1. Measure the battery voltage with the ignition switch off.

      Standard Voltage

      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

   NEXT

3. CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK* (CAN)

   1. Use the GTS to check if the CAN communication system is functioning normally.

      Result

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

   B

   GO TO CAN COMMUNICATION SYSTEM

   Click here

   A

4. CHECK FOR DTC*

   Refer to DTC Check / Clear.

   Click hereClick here

   1. Check for DTCs and note any codes that are output.

   2. Clear the DTCs.

   3. Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.

      Result

      Result	Proceed to
      DTC does not reoccur	A
      DTC reoccurs	B

   B

   GO TO DTC CHART

   Click hereClick hereClick here

   A

5. PROBLEM SYMPTOMS TABLE

   Refer to Problem Symptoms Table.

   Click hereClick hereClick here

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table	A
   Fault is listed in Problem Symptoms Table	B

   B

   ADJUST, REPAIR OR REPLACEClick here

   A

6. OVERALL ANALYSIS AND TROUBLESHOOTING*

   1. Terminals of ECU

      Click hereClick hereClick here

   2. Data List / Active Test

      Click hereClick here

   Result

   Proceed to
   NEXT

   NEXT

7. ADJUST, REPAIR OR REPLACE

   Result

   Proceed to
   NEXT

   NEXT

8. CONFIRMATION TEST

   Result

   Proceed to
   NEXT

   NEXT

   END