STEERING SYSTEM PRECAUTION

HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM

w/ Occupant Classification System:Click here

w/o Occupant Classification System:Click here

HANDLING PRECAUTIONS FOR STEERING COLUMN

1. When handling the steering column assembly:

   1. Avoid any impact to the steering column assembly, especially to the motor or torque sensor. Replace the steering column assembly with a new one if it is dropped or subjected to any severe impacts.

   2. Do not pull the wire harness when moving the steering column assembly.

   3. When the steering column assembly or other steering-related parts have been removed and either reinstalled or replaced, perform steering center point adjustment (zero point calibration).

   4. Do not release the tilt lever when the steering column assembly is not installed on the vehicle.

2. When disconnecting or reconnecting the connectors.

   1. When disconnecting connectors related to the electronic power steering system, turn the ignition switch to ON, center the steering wheel, turn the ignition switch off, and then disconnect the connectors.

   2. When reconnecting connectors related to the electronic power steering system, make sure that the ignition switch is turned off, center the steering wheel and then turn the ignition switch to ON.

      Note:

      Do not turn the ignition switch to ON without the steering wheel being centered.

   3. If the above operations are not carried out correctly, the steering center point (zero point) will deviate, causing a difference in steering effort between right and left turns. If there is a difference in the steering effort between right and left turns, perform the steering center point adjustment (zero point calibration).