FRONT BRAKE (for TMT Made 2WD) DISASSEMBLY

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE CYLINDER BOOT


    1. A01E2STE01

      Using a screwdriver, pry out the set ring and boot.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      Be careful not to damage the brake piston and cylinder.

  2. REMOVE FRONT DISC BRAKE PISTON


    1. A01DXI6E11

      Prepare a wooden plate to hold the piston.

    2. A01E2EH

      Place the wooden plate between the piston and cylinder.

    3. Use compressed air to remove the piston from the cylinder.

      CAUTION:

      Do not place your fingers in front of the piston when using compressed air.

      Note

      Be careful not to spatter the brake fluid.

  3. REMOVE PISTON SEAL


    1. A01E30QE01

      Using a screwdriver, pry out the seal from the cylinder.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      Be careful not to damage the inner cylinder and cylinder groove.

  4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP

  5. REMOVE FRONT DISC BRAKE BLEEDER PLUG


    1. Remove the bleeder plug from the cylinder.