POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows) Jam Protection Function does not Operate

DTC Code DTC Name
Jam Protection Function does not Operate

DESCRIPTION

This symptom may occur for any of the windows.

The jam protection function operates within a specified range during the manual up or auto up operation.

CAUTION / NOTICE / HINT

Note:

If a door window regulator assembly has been replaced with a new one, initialize the power window control system.

Click here

PROCEDURE

  1. PERFORM INITIALIZATION (APPLICABLE LOCATION)

    1. Initialize the door window regulator assembly (applicable location).

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  2. CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)

    1. Check if the power window auto up and down function operates normally.

      Click here

      OK

      Auto up and down function is normal.

    Result

    Proceed to

    OK

    NG
    NG

    GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)

    Click here

    OK

  3. CHECK JAM PROTECTION FUNCTION OPERATING RANGE

    1. Check if the jam protection function operates normally for the applicable power window.

      Tip:

      The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.

      OK

      Jam protection function operates normally.

    Result

    Result

    Proceed to

    OK

    A

    NG (Driver door power window)

    B

    NG (Front passenger door power window)

    NG (Rear LH door power window)

    C

    NG (Rear RH door power window)
    A

    END (PROBLEM DUE TO INITIALIZATION FAILURE)

    B

    REPLACE FRONT DOOR WINDOW REGULATOR ASSEMBLY (FOR DRIVER DOOR OR PASSENGER DOOR)

    Click here

    C

    REPLACE REAR DOOR WINDOW REGULATOR ASSEMBLY (FOR LH DOOR OR RH DOOR)

    Click here