FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE

  1. INSTALL TIMING CHAIN COVER OIL SEAL

    1. A157500E01

      Apply MP grease to the lip of a new oil seal.

      Note:

      • Do not allow foreign matter to contact the lip of the oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

      09223-22010

      Note:

      • Wipe off any extra grease from the crankshaft.

      • Do not tap in the oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY

    1. A200712E04

      Align the key groove of the pulley with the pulley set key.

    2. Temporarily install the pulley with the pulley bolt.

    3. Using SST, hold the pulley in place and tighten the bolt.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      09213-58014

      91551-80840

      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      09213-54015

      09330-00021

      190 N*m

      1940 kgf*cm

      140 ft.*lbf

      Table 1. Text in Illustration

      *1

      Hold

      *2

      Turn
      Tip:

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

  3. INSTALL V-RIBBED BELT

    Click here

  4. ADJUST V-RIBBED BELT

    Click here

  5. INSPECT V-RIBBED BELT

    Click here

  6. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  7. ADD ENGINE OIL

    Click here

  8. INSPECT FOR ENGINE OIL LEAK

    Click here

  9. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  10. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  11. INSTALL RADIATOR SUPPORT OPENING COVER

    Click here

  12. INSTALL NO. 2 CYLINDER HEAD COVER

    Click here