DIESEL THROTTLE BODY REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 ENGINE COVER

    Click here

  4. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  5. REMOVE FRONT LOWER BUMPER ABSORBER

    Click here

  6. REMOVE ENGINE UNDER COVER

    Click here

  7. DRAIN ENGINE COOLANT

    Click here

  8. REMOVE NO. 3 AIR HOSE


    1. A004NRB

      Loosen the 2 hose clamps.

    2. Remove the No. 3 air hose from the No. 2 air tube and diesel throttle body.

  9. REMOVE DIESEL THROTTLE BODY ASSEMBLY


    1. A004S68

      Disconnect the No. 7 water by-pass hose from the throttle body.

    2. Disconnect the No. 6 water by-pass hose from the throttle body.

    3. Disconnect the throttle position sensor and throttle motor connector.

    4. A004O8S

      Remove the 2 nuts, 2 bolts, diesel throttle body and gasket.