PARK / NEUTRAL POSITION SWITCH REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. SECURE VEHICLE

    1. Fully apply the parking brake and chock a wheel.

      CAUTION:

      • Make sure to apply the parking brake and chock a wheel before performing this procedure.

      • If the vehicle is not secure and shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick here

  4. REMOVE NO. 2 CYLINDER HEAD COVER (for 1ZR-FAE)

    Click hereClick hereClick here

  5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (for 1ZR-FAE)

    Click here

  6. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE (for 8NR-FTS)

    Click hereClick here

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 1ZR-FAE)

    Click hereClick hereClick here

  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 8NR-FTS)

    Click hereClick hereClick hereClick here

  9. REMOVE BATTERY (for 1ZR-FAE)

    Click hereClick hereClick here

  10. REMOVE BATTERY CARRIER ASSEMBLY (for 1ZR-FAE)

    Click hereClick hereClick here

  11. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    1. Move the shift lever to N.

    2. C327175

      Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

    3. Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

  12. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    1. C278997

      Disconnect the park/neutral position switch assembly connector.

    2. Remove the nut, washer and control shaft lever from the park/neutral position switch assembly.

    3. C151658

      Using a screwdriver, bend back the tabs of the lock plate and remove the lock nut and lock plate from the park/neutral position switch assembly.

    4. C151659

      Remove the 2 bolts and park/neutral position switch assembly from the transaxle case.