BRAKE PEDAL(for RHD) INSTALLATION

PROCEDURE

  1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

    1. Install the nut to the brake pedal support assembly.

    2. C269483N01

      Install the brake pedal support assembly with the 4 nuts.

      12.7 N*m

      130 kgf*cm

      9 ft.*lbf

      Note:

      Tighten the 4 nuts in the order shown in the illustration.

    3. C269482N01

      Engage the clamp (a) to install the wire harness to the brake pedal support assembly.

    4. for Manual Transaxle:

      Engage the clamp (b) to install the wire harness to the brake pedal support assembly.

    5. Install the brake pedal support assembly to the instrument panel reinforcement assembly with the bolt.

      23.6 N*m

      241 kgf*cm

      17 ft.*lbf

  2. INSTALL PUSH ROD PIN

    1. C251262C01
      V100145

      Lithium Soap Base Glycol Grease

      Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal support assembly.

    2. C269481

      Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin as shown in the illustration and install a new clip.

      Note:

      Install the push rod pin in the correct direction.

  3. INSTALL BRAKE PEDAL RETURN SPRING

    1. Install the brake pedal return spring to the brake pedal support assembly and push rod pin.

  4. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

    Click here

  5. INSTALL STOP LIGHT SWITCH ASSEMBLY

    Click here

  6. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Tip:

    Use the same procedure as for LHD.

    for Sedan:Click hereClick here

    for Hatchback, Wagon:Click here

  7. INSTALL COMBINATION METER ASSEMBLY

    Tip:

    Use the same procedure as for LHD.

    for Sedan:Click hereClick here

    for Hatchback, Wagon:Click here

  8. INSPECT AND ADJUST BRAKE PEDAL

    Click here