AIR SUSPENSION SYSTEM PROBLEM SYMPTOMS TABLE

Tip:
  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Table 1. Air Suspension System

Symptom

Suspected Area

Link

Suspension control ECU does not operate

Harness or connector (power source of suspension control ECU)

Click here

Suspension control ECU

Air suspension system DTC cannot be output (when using intelligent tester)

CAN communication system

Click here

Harness or connector (power source of suspension control ECU)

Click here

Suspension control ECU

Air suspension system DTC cannot be output (when not using intelligent tester)

CAN communication system

Click here

Harness or connector (power source of suspension control ECU)

Click here

Suspension control ECU

Combination meter assembly

Click here

Height control indicator does not come on

CAN communication system

Click here

Combination meter assembly

Click here

Harness or connector (power source of suspension control ECU)

Click here

Suspension control ECU

Height control indicator does not change even though vehicle height modes are switched using height control switch

Check test mode DTC (height control switch signal check)

Suspension control relay (AIR SUS relay)

-

Compressor motor

Click here

Harness or connector (power source of compressor motor)

Click here

Continuous electric current to height control

Click here

Suspension control ECU

Height control cannot be disabled using height control OFF switch

Check test mode DTC (height control OFF switch signal check)

Suspension control ECU

Vehicle is not level

Air leakage

Adjust height control sensor link

Height control sensor

Suspension control ECU

Warning message is shown on multi-information display even though DTC is not output

Connect of the connector

-

CAN communication system

Click here

Harness or connector (power source of suspension control ECU)

Click here

Combination meter assembly

Click here

Suspension control ECU