PERSONAL LIGHT INSPECTION

PROCEDURE

  1. INSPECT MAP LIGHT ASSEMBLY

    1. E303110C04

      *a

      Component without harness connected

      (Map Light Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      1 (+B1) - 20 (GND)

      Map light switch LH OFF

      10 kΩ or higher

      Map light switch LH ON

      Below 1 Ω

      Map light switch RH OFF

      10 kΩ or higher

      Map light switch RH ON

      Below 1 Ω

      1 (+B1) - 18 (CTY)

      Courtesy switch OFF position

      10 kΩ or higher

      Courtesy switch DOOR position

      Below 1 Ω

      If the result is not as specified, replace the map light assembly.