OIL PRESSURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the oil pressure sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced

Replacement Part or Procedure

Necessary Procedures

Effects/Inoperative when not Performed

Link

Replacement of oil pressure sensor

  • Reset memory

  • Deceleration sensor zero point calibration

  • CVT oil pressure calibration

  • DTC P1589 is output (Malfunction Indicator Lamp (MIL) not iilluminated)

  • Deterioration of fuel efficiency

Click hereClick here

PROCEDURE

  1. REMOVE FRONT WHEEL LH

  2. REMOVE REAR ENGINE UNDER COVER LH

    Click hereClick hereClick here

  3. REMOVE OIL PRESSURE SENSOR

    C296018

    1. Disconnect the oil pressure sensor connector.

    2. C328303N01

      Using SST, remove the oil pressure sensor from the continuously variable transaxle assembly.

      09326-22011