FRONT SEAT ASSEMBLY(for Power Seat) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:


  • B0025TC

    Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

PROCEDURE


  1. INSTALL FRONT SEAT ASSEMBLY LH


    1. B0027S6

      Place the front seat assembly LH in the vehicle, as shown in the illustration.

      Note

      Do not damage the front seat assembly LH, body exterior or interior parts.

    2. B0025XJ

      Attach the wire harness clamp.

    3. Connect the 2 connectors.

    4. w/ Side Airbag System:

      Connect the front seat airbag assembly LH connector.

    5. Connect the cable to the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

    6. Temporarily install the front seat assembly LH with the 4 bolts.

    7. Operate the power seat switch knob LH (for Slide) to slide the front seat assembly LH to the rearmost position.

    8. B0024TFN01

      Tighten the 2 bolts on the front side of front seat assembly LH in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    9. Operate the power seat switch knob LH (for Slide) to slide the front seat assembly LH to the frontmost position.

    10. B00267TN01

      Tighten the 2 bolts on the rear side of front seat assembly LH in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

  2. INSTALL FRONT SEAT REAR INNER TRACK COVER LH (w/ Cover)


    1. B00274IC01
      B0069FO Install in this Direction (1)
      B0068NX Install in this Direction (2)

      Push in installation direction (1) shown in the illustration to attach the guide.

    2. Push in installation direction (2) shown in the illustration to attach the claw and install the front seat rear inner track cover LH.

  3. INSTALL FRONT SEAT REAR OUTER TRACK COVER LH (w/ Cover)


    1. B0024SVC01
      B0069FO Install in this Direction (1)
      B0068NX Install in this Direction (2)

      Push in installation direction (1) shown in the illustration to attach the guide.

    2. Push in installation direction (2) shown in the illustration to attach the claw and install the front seat rear outer track cover LH.

    3. Operate the power seat switch knob LH (for Slide) to slide the front seat assembly LH to the center position.

  4. PERFORM DIAGNOSTIC SYSTEM CHECK

    for AIRBAG SYSTEM (for Type A):

    Click here

    for AIRBAG SYSTEM (for Type B):

    Click here

    for AIRBAG SYSTEM (for Type C):

    Click here

  5. CHECK SRS WARNING LIGHT

    for AIRBAG SYSTEM (for Type A):

    Click here

    for AIRBAG SYSTEM (for Type B):

    Click here

    for AIRBAG SYSTEM (for Type C):

    Click here