PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) DATA LIST / ACTIVE TEST

  1. DATA LIST

    Note:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / Parking Assist Monitor / Data List.

    5. Enter the following menus: Body Electrical / Main Body / Data List.

    6. Read the Data List according to the display on the GTS.

      Chassis > IPA/Parking Assist Monitor > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      EEPROM Status (Initial read)

      Television camera assembly information

      OK or NG

      OK: Television camera assembly is normal

      NG: Television camera assembly is abnormal

      -

      CPU Communication Status

      Status of the CPU Communication Check

      OK or NG

      OK: Status of the CPU communication is normal

      NG: Status of the CPU communication is abnormal

      -

      ASIC Output Status

      Output condition of camera display signal

      OK or NG

      OK: Output condition of camera display signal is normal

      NG: Output condition of camera display signal is abnormal

      If "NG" is displayed, there is a malfunction in the television camera assembly.

      Wheel Speed Sensor (4wheel)

      Status of the Wheel Speed Sensor (4 wheel) Check

      OK or NG

      OK: Status of the Wheel Speed Sensor (4 wheel) is normal

      NG: Status of the Wheel Speed Sensor (4 wheel) is abnormal

      -

      Parking Assist Function of Camera

      Status of the parking assist function of camera

      Valid or Invalid

      Valid: Status of the parking assist function of camera is vaild

      Invalid: Status of the parking assist function of camera is invalid

      -

      Number of DTC

      Number of trouble codes

      Min.: 0

      Max.: 255

      Number of DTCs displayed

      -

      Body Electrical > Main Body > Data List

      Tester Display

      Measurement Item

      Range

      Normal Condition

      Diagnostic Note

      Back Door Courtesy SW

      Back door courtesy switch signal

      ON or OFF

      ON: Back door open

      OFF: Back door closed

      -