HEIGHT CONTROL SENSOR INSPECTION

PROCEDURE

1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for Torsion Beam Type Suspension)

   1. Connect 3 dry cell batteries (1.5 V) in series.

      Note:

      Do not use rechargeable batteries as they may not output a voltage of 1.5 V.

      

      *a	Component without harness connected (Rear Height Control Sensor Sub-assembly)	*b	Low
      *c	Standard position	*d	High
      *e	-35.02°	*f	11.9°
      *g	+39.09°	-	-

   2. Connect a positive (+) lead from the batteries to terminal 3 (SHB) and a negative (-) lead to terminal 1 (SHG).

   3. Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.

      Standard Voltage

      Tester Connection	Condition	Specified Condition
      2 (SHRR) - 1 (SHG)	+39.09° (High)	3.81 V
      2 (SHRR) - 1 (SHG)	0° (Standard position)	2.25 V
      2 (SHRR) - 1 (SHG)	-35.02° (Low)	0.85 V

      If the result is not as specified, replace the rear height control sensor sub-assembly.

2. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for Double Wishbone Type Suspension)

   1. Connect 3 dry cell batteries (1.5 V) in series.

      Note:

      Do not use rechargeable batteries as they may not output a voltage of 1.5 V.

      

      *a	Component without harness connected (Rear Height Control Sensor Sub-assembly)	*b	Low
      *c	Standard position	*d	High
      *e	-34.08°	*f	22.7°
      *g	+33.74°	-	-

   2. Connect a positive (+) lead from the batteries to terminal 3 (SHB) and a negative (-) lead to terminal 1 (SHG).

   3. Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.

      Standard Voltage

      Tester Connection	Condition	Specified Condition
      2 (SHRR) - 1 (SHG)	+33.74° (High)	3.60 V
      2 (SHRR) - 1 (SHG)	0° (Standard position)	2.25 V
      2 (SHRR) - 1 (SHG)	-34.08° (Low)	0.89 V

      If the result is not as specified, replace the rear height control sensor sub-assembly.