GENERATOR INSTALLATION

PROCEDURE

1. INSTALL GENERATOR ASSEMBLY

   1. Install the wire harness clamp bracket with the bolt.

      8.4 N*m

      85 kgf*cm

      74 in.*lbf

   2. Temporarily install the generator assembly with the bolt.

   3. Temporarily install the adjusting bar with the 2 bolts.

   4. 

      Tighten the bolt.

      25 N*m

      255 kgf*cm

      18 ft.*lbf

   5. Install the wire harness to terminal B with the nut and install the terminal cap.

      9.8 N*m

      100 kgf*cm

      87 in.*lbf

   6. Connect the connector and attach the wire harness clamp.

2. INSTALL V-RIBBED BELT

   Click here

3. ADJUST V-RIBBED BELT

   Click here

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

5. INSPECT V-RIBBED BELT

   Click here

6. INSTALL REAR ENGINE UNDER COVER RH

   Click here

7. INSTALL NO. 2 CYLINDER HEAD COVER

   Click here

8. INSTALL RADIATOR SUPPORT OPENING COVER

   Click here