ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator reservoir cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

    Tech Tips

    Collect the engine coolant in a container and dispose of it according to the local regulations.


    1. Loosen the radiator drain cock plug and drain the engine coolant.

      B007TU6E01
      Text in Illustration
      *1 Radiator Reservoir Cap Sub-assembly *2 Radiator Reservoir Assembly
      *3 Radiator Drain Cock Plug *4 Cylinder Block Water Drain Cock Plug
      *5 2-Way - -

    2. Remove the radiator reservoir cap sub-assembly.

    3. Loosen the cylinder block water drain cock plug and drain the engine coolant from the engine.

  4. REMOVE THROTTLE BODY ASSEMBLY

    Click here

  5. REMOVE FUEL INJECTOR ASSEMBLY

    Click here

  6. REMOVE INTAKE MANIFOLD


    1. Disconnect the vacuum switching valve connector.

    2. Slide the clamp and disconnect the purge line hose from the vacuum switching valve.

    3. B007TSE

      Detach the 2 wire harness clamps from the wire harness bracket.

    4. Slide the clamp and disconnect the No. 3 PCV hose from the intake manifold.

    5. Slide the clamp and disconnect the vacuum hose from the intake manifold.

    6. B007RIP

      Remove the bolt and wire harness bracket from the intake manifold.

    7. B007Q6O

      Remove the 5 bolts, 2 nuts and intake manifold.

    8. Remove the gasket from the intake manifold.

    9. Remove the intake manifold insulator from the intake manifold.

  7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. Disconnect the engine coolant temperature sensor connector.

    2. B007PJZ

      Using a 19 mm deep socket wrench, remove the engine coolant temperature sensor and gasket.