KNEE AIRBAG ASSEMBLY(for Sedan) REMOVAL

PROCEDURE

  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  3. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  4. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY

    Click here

  6. REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for LHD)

    Click here

  7. REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for RHD)

    Click here

  8. REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  9. REMOVE NO. 1 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY

    Click here

  10. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    Click here

  11. REMOVE NO. 1 SWITCH HOLE BASE (for LHD)

    Click here

  12. REMOVE NO. 1 SWITCH HOLE BASE (for RHD)

    Click here

  13. REMOVE NO. 2 SWITCH HOLE BASE (for RHD without Entry and Start System)

    Click here

  14. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Instrument Panel Under Cover)

    Click here

  15. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY WITH DOOR

    CAUTION:

    When storing the lower No. 1 instrument panel airbag assembly with door, keep the airbag deployment side facing upward.

    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B324553

      Remove the 4 bolts.

    4. B355844

      Disengage the 7 claws and 2 guides to separate the lower No. 1 instrument panel airbag assembly with door.

      Note:

      When removing the lower No. 1 instrument panel airbag assembly with door, do not pull the airbag wire harness.

    5. B324555C03

      *a

      Airbag Connector

      *b

      Airbag Connector Lock

      *c

      Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock.

    6. Disconnect the airbag connector to remove the lower No. 1 instrument panel airbag assembly with door.

      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  16. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    B345310

    1. Disengage the 8 hooks to remove the lower No. 1 instrument panel airbag assembly from the lower No. 1 instrument panel airbag door.