AUDIO AND VISUAL SYSTEM(for Sedan Radio and Display Type) Mute Signal Circuit between Radio Receiver and Telematics Transceiver

DTC Code DTC Name
Mute Signal Circuit between Radio Receiver and Telematics Transceiver

DESCRIPTION

The telematics transceiver sends a mute signal to the radio and display receiver assembly.

The radio and display receiver assembly controls the volume according to the mute signal from the telematics transceiver.

WIRING DIAGRAM

E336503E10

CAUTION / NOTICE / HINT

Note:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click here

PROCEDURE

  1. INSPECT TELEMATICS TRANSCEIVER

    1. E259127C35

      *a

      Component with harness connected

      (Telematics Transceiver)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection

      Condition

      Specified Condition

      E143-17 (MUTE) - Body ground

      Ignition switch ACC

      Audio system playing

      → Emergency call mode

      2.0 V or higher

      → Below 1 V

    Result

    Proceed to

    OK

    NG
    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - TELEMATICS TRANSCEIVER)

    1. Disconnect the E1 radio and display receiver assembly connector.

    2. Disconnect the E143 telematics transceiver connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      E1-8 (TMUT) - E143-17 (MUTE)

      Always

      Below 1 Ω

      E1-8 (TMUT) or E143-17 (MUTE) - Body ground

      Always

      10 kΩ or higher

    Result

    Proceed to

    OK

    NG
    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY

    1. Reconnect the E1 radio and display receiver assembly connector.

    2. E176650C28

      *a

      Front view of wire harness connector

      (Telematics Transceiver)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection

      Condition

      Specified Condition

      E143-17 (MUTE) - Body ground

      Ignition switch ACC

      2.0 V or higher

    Result

    Proceed to

    OK

    NG
    OK

    REPLACE TELEMATICS TRANSCEIVER

    Click here

    NG

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

    Click here