BACK DOOR SUPPORT REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. REMOVE BACK DOOR STAY ASSEMBLY LH

    Note:

    • Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

    • Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

    • Do not apply any horizontal load to the door stay in order to prevent the piston rod from deforming.

    1. B336845C01

      *a

      Protective Tape

      Using a screwdriver, remove the 2 stop rings as indicated by the arrows in the order shown in the illustration.

      Tip:

      Tape the screwdriver tip before use.

    2. Release the ball joint and remove the back door stay assembly LH.

      Note:

      Remove the back door stay assembly while supporting the back door by hand.

  2. REMOVE BACK DOOR STAY ASSEMBLY RH

    Tip:

    Use the same procedure described for the LH side.

  3. REMOVE BACK DOOR DAMPER STAY UPPER BRACKET LH

    1. B336846

      Remove the 2 bolts and back door damper stay upper bracket LH.

  4. REMOVE BACK DOOR DAMPER STAY UPPER BRACKET RH

    Tip:

    Use the same procedure described for the LH side.

  5. REMOVE BACK DOOR DAMPER STAY LOWER BRACKET LH

    1. B336847

      Remove the 2 bolts and back door damper stay lower bracket LH.

  6. REMOVE BACK DOOR DAMPER STAY LOWER BRACKET RH

    Tip:

    Use the same procedure described for the LH side.