FUEL PUMP INSPECTION

PROCEDURE

1. INSPECT FUEL PUMP

   

   1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection	Condition	Specified Condition
      1 - 2	20°C (68°F)	0.2 to 3.0 Ω

      Table 1. Text in Illustration

      *1	Component without harness connected (Fuel Pump)

      If the result is not as specified, replace the fuel pump assembly.

   2. Inspect the operation of the fuel pump.

      1. 

         Connect the positive (+) lead of the battery to terminal 1 of the connector, and the negative (-) lead to terminal 2. Check that the fuel pump operates.

         Table 2. Text in Illustration

         *1	Component without harness connected (Fuel Pump)

         If the pump does not operate, replace the fuel pump assembly.

         Note:

         • This test must be performed within 10 seconds to prevent the coil from burning out.

         • Keep the fuel pump as far away from the battery as possible.

         • Always turn the voltage on and off on the battery side, not the fuel pump side.