DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL FAN AND GENERATOR V BELT


    1. Using SST and a 22 mm wrench, rotate the tensioner pulley counterclockwise, and then install the fan and generator V belt.

      SST
      09216-42010

      CAUTION:


      • Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.

      • Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.

      Note


      • Make sure that the belt is set properly on each pulley.

      • Make sure SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.

      A004MYJE01
      *1 w/o Air Conditioning System:
      *2 w/ Air Conditioning System:

  2. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A004RXSE02

      Install the front suspension member reinforcement with the 4 bolts.

      Torque:
      99 N*m  { 1010 kgf*cm, 73 ft.*lbf }

      Note

      Tighten the bolts in the order shown in the illustration.

  3. INSTALL REAR ENGINE UNDER COVER RH


    1. A004RW7

      Install the under cover with the 5 clips.

  4. INSTALL NO. 1 ENGINE UNDER COVER

    Click here