STEREO COMPONENT AMPLIFIER(for 14 Speakers) INSTALLATION

PROCEDURE

1. INSTALL NO. 1 AMPLIFIER BRACKET

   1. Install the No. 1 amplifier bracket with 2 screws.

      3.0 N*m

      31 kgf*cm

      27 in.*lbf

2. INSTALL NO. 2 AMPLIFIER BRACKET

   1. Install the No. 2 amplifier bracket with 2 screws.

      3.0 N*m

      31 kgf*cm

      27 in.*lbf

3. INSTALL STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET

   1. Install the stereo component amplifier assembly with bracket with the 3 bolts.

      8.0 N*m

      82 kgf*cm

      71 in.*lbf

   2. Connect the 4 connectors.

4. INSTALL AMPLIFIER BRACKET

   1. Install the amplifier bracket with the 2 bolts.

      12 N*m

      122 kgf*cm

      9 ft.*lbf

5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

   Click here

6. INSTALL ASSIST GRIP SUB-ASSEMBLY (w/ Rear No. 2 Seat)

   Click here

7. INSTALL ASSIST GRIP PLUG (w/ Rear No. 2 Seat)

   Click here

8. INSTALL FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)

   Click here

9. INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)

   Click here

10. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

    Click here

11. INSTALL REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER

    Click here

12. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

13. INSTALL OUTER LAP BELT ANCHOR COVER

    Click here

14. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

15. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

16. INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

    Click here

17. INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

    Click here

18. INSTALL REAR NO. 1 SEATBACK ASSEMBLY

    1. for 60/40 Split Slide Walk-in Seat Type LH Side:

       Install the rear No. 1 seatback assembly (Click here).

    2. for 60/40 Split Slide Walk-in Seat Type RH Side:

       Install the rear No. 1 seatback assembly (Click here).

19. INSTALL REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat)

    1. Install the rear No. 2 seat assembly (Click here).

20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).