CHARGING SYSTEM(w/ Stop And Start System) PRECAUTION

  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

  2. IGNITION SWITCH EXPRESSIONS

    1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Expression

      Ignition Switch (Position)

      Engine Switch (Condition)

      Ignition Switch off

      LOCK

      Off (Lock)

      Ignition Switch ACC

      ACC

      On (ACC)

      Ignition Switch ON

      ON

      On (IG)

      Engine Start

      START

      On (Start)
Note:

When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

System Name

See Procedure

Stop and Start System

Click hereClick hereClick here

Power Door Lock Control System
Note:

  • Check that the battery cables are connected to the correct terminals.

  • Disconnect the battery cables when the battery is given a quick charge.

  • Do not perform tests with a high voltage insulation resistance tester.

  • Never disconnect the battery cables while the engine is running.

  • Check that the charging cable nuts are tightened on terminal B of the generator assembly and on the No. 1 engine room relay block.