POWER SEAT SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization, or registration) that must be per formed after parts are removed, installed, or replaced during the power seat switch removal / installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 40 minutes) Stop and start system

Click here

Memorize steering angle neutral point Pre-crash safety system

Click here

CAUTION:


  • B0025TC

    Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  2. REMOVE POWER SEAT SWITCH KNOB LH (for Slide and Vertical, Lifter)

    Click here

  3. REMOVE POWER SEAT SWITCH KNOB LH (for Reclining)

    Click here

  4. REMOVE FRONT SEAT INNER NO. 1 CUSHION SHIELD LH

    Click here

  5. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  6. REMOVE FRONT POWER SEAT SWITCH LH


    1. A01SJWW

      Remove the 3 screws and front power seat switch LH.