ГЕНЕРАТОР РАЗБОРКА


  1. REMOVE GENERATOR WITH CLUTCH PULLEY


    1. Remove the generator pulley cap.

    2. B007R32E01

      Install SST to the pulley and vise as shown in the illustration.

      SST
      09820-63020

    3. Mount SST (A) in a vise.

    4. B007VQDE01

      Turn SST (B) clockwise, and loosen the pulley.

    5. Remove the pulley.

  2. REMOVE GENERATOR REAR END COVER


    1. B007QZP

      Remove the 3 nuts and generator rear end cover.

  3. REMOVE TERMINAL INSULATOR


    1. B007Q7C

      Remove the terminal insulator.

  4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    1. B007TMP

      Remove the 2 screws and generator brush holder assembly.

  5. REMOVE GENERATOR COIL ASSEMBLY


    1. B007SSU

      Remove the 4 through bolts.

    2. B007PI3E01

      Using SST, remove the generator coil.

      SST
      09950-40011   ( 09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011 )

    3. Remove the generator washer.

  6. REMOVE GENERATOR ROTOR ASSEMBLY


    1. Remove the generator rotor from the drive end frame.

  7. INSPECT GENERATOR DRIVE END FRAME BEARING


    1. B007VL6

      Inspect than the bearing is not rough or worn. If necessary, replace the bearing.

  8. REMOVE GENERATOR DRIVE END FRAME BEARING


    1. B007QU8

      Remove the 4 screws and bearing retainer.

    2. B007RGAE01

      Using SST, tap out the bearing.

      SST
      09950-60010   ( 09951-00250 )
      09950-70010   ( 09951-07100 )